Page Comparison

...

• Backup your data

  • Though the update process does not affect your data at all, it is recommended that you backup your data… just in case.

• Know that if you are facing any issues with the v3.10.1 firmware, you can always downgrade your firmware back to v3.9. The links to the previous editor versions are available at the bottom of the Editor.

After Updating

• Check your Controller Settings. Check that the USB Virtual MIDI Ports setting is set to 1, and then SAVE your settings.

  • The default USB Virtual MIDI Ports setting might be set to 0 and no MIDI messages will be send via USB if that’s the case. The above step is just to initialise the value for this new setting.
    

New Features

• New USB MIDI interface exposes 4 virtual MIDI ports.

  • Not an issue for MacOS users as one port can be used by multiple applications (just set the USB Virtual MIDI Ports setting in the Controller settings to 1 if not you’ll see more than 1 MIDI message for each usbMIDI command sent). Windows OS only allows 1 MIDI port to be used by 1 application, so you can’t connect the controller to, for example, Ableton and the Editor at the same time

  • The first port is meant for the Editor. Editor SysEx messages are not sent on the other ports.

• New Added MIDI Delay setting in Controller Settings

  • Increase time between PC and CC messages. Applies to PC and CC messages only

  • Some devices cannot process incoming stream of CC messages that are sent too fast.

  • More delay + more messages = more latency. Probably cannot be observed if delay is kept to 2-3ms.

• New Fixed Switch Custom action: Toggle Active Preset

• New Added Focus Mode for MC8

  • Focus Mode just displays the preset labels and nothing else.

• New Omniport Settings

  • Set Expression Sensitivity and Expression Calibration from Editor in Omniport settings.

    • Setting needs to be saved and device restarted first.

...