The Omniport Relay Interface (ORI) allows you to interface the Omniports on your MC3 / MC6MKII / MC8 with other devices that has switching inputs.
The ORI has
a 9VDC Center Negative input
a Omniport In 1/4” Jack to connect to the Omniport with a TRS cable
a Relay Out 1/4” Jack to connect to the switching input of the device that you want to control
The LED indicators on the ORI lights up
Power - when the ORI is connected to a power source
Tip - When the Tip connection is shorted to Ground
Ring - When the Ring connection is shorted to Ground
The ORI allows you to safely control other TRS switching inputs without damaging your Omniports. There is no standard for TRS switching and different devices works at different voltages and currents. Hence, the ORI is required to safely interface the Omniports to other TRS switch inputs. |
The Relay Out jack is a TRS jack that switches by pulling the
Tip to Ground
Ring to Ground
Tip and Ring to Ground
In the Configure Omniport settings for your MIDI controller, set the port to Ext Omniport Relay Interface
After which, connect a TRS cable from the Omniport to the Omniport In jack in the ORI.
To control the ORI, simply program a preset in your MIDI Controller. Use the Morningstar Relay Interface message type, then select the Omniport that your ORI is connected to.
Next, select the action you want for the Tip and Ring when the preset is engaged.
The available options are:
Tap - NO
Shorts the connection to ground momentarily before reverting back to a Normally Open (NO) connection
Tap - NC
Breaks the connection to ground momentarily before reverting back to a Normally Closed (NC) connection
Engage
Connect to ground
Disengage
Break the connection from ground
Toggle
Toggle between engage and disengage
Requires at least 80mA at 9vDC
120VAC / 24VDC at 1A