...
The Switch Sensitivity setting in the controller settings can be set to 5, which is the highest setting. This will remove any latency when the controller boots up. However, you will notice that as the sensitivity gets higher, it will also be harder to execute dual switch presses. This is not a problem if you are using other means to change banks, like an external aux switch, or programming a preset to execute the bank change.
| Info |
|---|
The switch sensitivity can be set in the Editor, under Controller Settings → General Configurations |
Looper Mode
The controller can also be put into a state called Looper Mode, which is similar to having the Switch Sensitivity set to 5. This feature is documented here: Looper Mode for Zero-latency Looper Control
...